Purchase Project

(If you are a magazine subscriber, please sign in first as this project and/or edition may already be in your subscription.)

The Pen Turner's Corner: Spheres Anyone?
By Don Ward

For: Intermediate Turners


A friend who owns a cabinet and millwork business called and asked if I could make spheres. “Sure”, I said. He had seen some of the smaller ones I had made: up to seven inches in diameter. “Can you turn 12 inch spheres? ”, he asked.  He needed six spheres and one half-sphere and they had to be “identical”.


** After purchasing this project, you will recieve a confirmation email explaining how to access your project for reading or printing. We will ask for your email address to create your account. It will not be used for any other purpose.



Purchase the Entire Magazine Edition
The project above was published in the February 2016 edition of the magazine. You may purchase the entire magazine edition by clicking on the "Purchase this edition" tab below. Here is a partial list of this edition's contents:

Turning Wood Dragonflies
by David Reed Smith

Fun with Mushrooms
by John Lucas

DIY Chuck Holding System
by Paul Rohrbacher

Attending Regional Symposia
by John Tarpley

On the Lighter Side: Chucking Chinquapin Chestnut
by Bob Heltman

Product Review:
New SC3 and SC4 Chucks from Record Power

by: Record Power