Purchase Project

(If you are a magazine subscriber, please sign in first as this project and/or edition may already be in your subscription.)


Making Threaded Wood Chucks
By Andy Kuby

Introduction

This article shows you how to make a threaded wood chuck. Using these wood chucks allows you to remove the work from the lathe for drying or other finishing work with the ability to remount the work at the same center on the original or another lathe. The sacrificial face can also be configured as a jam chuck, glue chuck or used to hold an off-center piece.

 

** After purchasing this project, you will recieve a confirmation email explaining how to access your project for reading or printing. We will ask for your email address to create your account. It will not be used for any other purpose.

 

 

Purchase the Entire Magazine Edition
The project above was published in the March 2016 edition of the magazine. You may purchase the entire magazine edition by clicking on the "Purchase this edition" tab below. Here is a partial list of this edition's contents:

Segmented Pencil Holder
by Al Miotke

Easy-to-make Turned Box with Plug Lid
by Ian Salisbury

The Pen Turner's Corner: Spheres Anyone? (Continued from Last Month)
by Don Ward

Upwards Turning Grinding for Sharpening
by Paul Rohrbacher

Dust Management
by Bill Rosener

Product Review:
The New Nova Infinity Chuck with Quick Change Jaws

by: Teknatool